Compact, portable, and even rack mountable, the TF1 offers impressive capability and versatility for smaller systems.

 

 

 

  • 17 motor faders (16 channels + 1 master)
  • 40 input mixing channels (32 mono + 2 stereo + 2 return)
  • 20 Aux buses (8 mono + 6 stereo) + Stereo + Sub
  • 8 DCA groups with Roll-out
  • 16 analog XLR/TRS combo mic/line inputs + 2 analog RCA pin stereo line inputs
  • 16 analog XLR outputs
  • 34 x 34 digital record/playback channels via USB 2.0 + 2 x 2 via a USB storage device
  • 8 Effects and 10 GEQ
  • 1 expansion slot for NY64-D audio interface card

Outline

Fader
Configuration
16 + 1 (Master)
Mixing
Capacity
Input Channels 40 (32 mono + 2 stereo + 2 return)
Aux Buses 20 (8 mono + 6 stereo)
Stereo Buses 1
Sub Buses 1
Input
channel functions
8 DCA Groups
I/O Inputs 16 mic/line (XLR/TRS combo) + 2 stereo line (RCA
pin)
Outputs 16 (XLR)
Expansion slots 1
On-board processors DSP 8 Effects + 10 GEQ

General specifications

Sampling frequency
rate
Internal 48 kHz
Signal
delay
Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz
Fader 100 mm motorized, Resolution = 10-bit, +10 dB to
–138 dB, –∞ dB all faders
Total
harmonic distortion
Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 ,
INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18
dB/octave filter@80 kHz)
Frequency
response
+0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output
@1kHz, INPUT to OMNI OUT
Dynamic
range
110 dB typ., DA Converter, 107 dB typ., INPUT to
OMNI OUT, Input Gain=Min.
Hum &
noise level
Equivalent input noise –128 dBu typ., Input Gain=Max. (Measured with an
A-Weight filter)
Residual output noise –85 dBu, ST master off (Measured with an A-Weight
filter)
Crosstalk –100 dB (Measured with a –30 dB/octave filter@22
kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min.
Power
requirements
100–240 V 50/60 Hz
Power
consumption
100 W
Dimensions W 510 mm (20.1in)
H 225 mm (8.9in)
D 599 mm (23.6in)
Net weight 13.5 kg (29.8lb)
Accessories Quick Guide, Power Cord, Nuendo Live
Options Rack-mount Kit RK5014, Expansion Card, Foot Switch
(FC5)
Others Operating temperature range: 0–40 °C, Storage
temperature range: -20–60 °C

Recording/ Playback

PC/Mac (USB2.0) Recording 34 tracks, Playback 34 tracks
USB Storage Device Recording 2 tracks (USB hard drive/ SSD)*, Playback
2 tracks (USB hard drive/ SSD/ thumb drive)

*Please note – USB thumb drives are
not supported by TF for recording purposes. Please refer to
this link
for compatible hard drives.

Analog input characteristics

Input
Terminals
GAIN Load
Impedance
For Use
With
Nominal
Input
Level
Connector balanced /
Unbalanced
Sensitivity*1 Nominal Max. before clip
 
INPUT1-16 +66dB 7.5KΩ
 
50-600Ω Mics
or 600Ω Lines
 
-82dBu (61.6V) -62dBu (0.616mV) -42dBu (6.16mV) Combo Jack (XLR-3-31 type *2
or TRS phone *3)
Balanced
-6dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V)
ST IN 1,2 10kΩ 600Ω Lines -30dBV (31.6V) -10dBV (316mV) +10dBV (3.16V) RCA Pin Jack Unbalanced

*1. Sensitivity is the lowest level
that will produce an output of +4dBu (1.23V) or the nominal
output level when the unit is set to maximum gain. (All faders
and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type
connectors via each individual software controlled switch.
 

Analog output characteristics

Output
Terminals
Source
Impedance
For Use
With
Nominal
GAIN SW Output
Level
Connector balanced /
Unbalanced
Nominal Max. before clip
OMNI OUT 1-16 75Ω 600Ω Lines
 
“+24dBu” position (default)

 

+4dBu (1.23 V) +24dBu (12.3 V) XLR-3-32 type *1 Balanced
PHONES *3 100Ω 40Ω Phones 3mW 75mW Stereo Phone Jack (TRS) *2 Unbalanced

*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the
maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.

Digital input/output specifications

Terminals Format Data length Audio Connector
USB (TO HOST) USB 24bit 34ch input / 34ch output, PCM USB (B type)
iPad USB Playback: MP3 or WAV file data / Record: WAV file
data
 
USB (A type)
 

 

Control I/O specifications

Terminals Format Level Connector
NETWORK IEEE802.3 10BASE-T/100Base-TX RJ-45
FOOT SW TS Phone